dot dot


ชื่อผู้ใช้ :
รหัสผ่าน :
เข้าสู่ระบบอัตโนมัติ :
bullet ลืมรหัสผ่าน
bullet สมัครสมาชิก
ตู้แรค rack ปลั๊กแจ๊ค สายสัญญาณ สายมัลติคอร์ PLUG JACK MULTICORE


รหัส : PX10
ยี่ห้อ : YAMAHA
รุ่น : PX10
ราคาปกติ :  42,000.00 บาท      
ราคาพิเศษ :  37,900.00บาท

รายละเอียดย่อ :
เครื่องขยายเสียง 2x 1000W at 8Ω, 2x 1200W at 4Ω, Class-D amplifier, PEQ, crossover, filters, delay, and limiter functions, 2U
รายละเอียดทั้งหมด :

 Yamaha PX10 Stereo Power Amplifier 

(1000W at 8 Ohms)

เครื่องขยายเสียง YAMAHA PX-Series PX10, 1000W per Channel at 8 Ohms, Class-D Amplifier, Digital Routing of Inputs & Outputs, PEQ, Crossover, Filters, Delay, D-Contour Multi-Band Dynamic Processing


The Yamaha PX10 Stereo Power Amplifier delivers 1000W at 8 Ohms in a lightweight chassis and is suitable for a wide variety of sound-reinforcement applications. Part of the company’s PX Series of power amplifiers, it features a Class-D engine with a single custom LSI chip, and uses PLL technology for higher efficiency and lower noise.

The on-board DSP functions include a PEQ, a delay, a crossover, and a limiter. They allow for detailed configuration of parameters such as input & output routing, input sensitivity, amp gain, and speaker impedance. The D-Control multi-band dynamic processor delivers a clear and consistent sound at any output level by shaping the frequency response of each speaker for either front-of-house or monitor configurations.

The Configuration Wizard helps save time during setup by assigning optimized speaker settings that match your system configuration. It can be used in basic mode for quick setup or advanced mode for more precise control over DSP parameters. You can store up to eight presets, which can be saved to a USB drive for use with other amplifiers and setups.

For secure operation, the panel-locking function ensures that your settings remain safe. With its sturdy frame and carrying handle, the PX10 is built to withstand extended road use.


  • Class-D amplifier engine with single custom LSI chip and PLL technology
  • Configuration Wizard allows for configuration of the system by assigning optimized speaker settings which can be saved as presets
  • Digital routing of inputs & output (dual, parallel, single & SUM)
  • DSP functions include PEQ, crossover, filters, delay & limiter, accessed via an LCD display
  • D-Contour multi-band dynamic processing shapes the frequency response of speakers for specific applications
  • Basic mode for quick setup and Advanced mode for more precise control
  • Flexible connectivity with XLR & 1/4″ TRS inputs and binding post, SpeakON & 1/4″ TS outputs
  • Presets can be saved to USB drive for use with other amplifiers and setups
  • Panel-locking function to keep settings safe
  • Two 16-step variable-speed fans
  • Lightweight chassis



Output Power 1000 W per channel at 8 Ohms
1200 W per channel at 4 Ohms
700 W per channel at 2 Ohms
Amplifier Type Class-D, balanced output circuit (BLT)
THD + N 0.1% at 1 kHz, 10 W
0.3% at 1 kHz, half power
Frequency Response 20 Hz to 20 kHz, ±1.0 dB (1 W at 8 Ohms)
Crosstalk ≤ -60 dB
S/N Ratio 101 dB
Voltage Gain / Sensitivity At 8 Ohms, Maximum Volume:


32.0 dB / +9.3 dBu (Gain Setting: 32 dB)
26.0 dB / +15.3 dBu (Gain Setting: 26 dB)
37.3 dB / +4 dBu (Gain Setting: 4 dB)
27.3 dB / +14 dBu (Gain Setting: 14 dB)

Cooling 2 x 16-step variable-speed fan (front-to-rear flow)
Maximum Input Voltage +24 dBu
Input Impedance 20 kOhms (Balanced)
10 kOhms (Unbalanced)
Sampling Frequency 48 kHz
Converters A/D: 24-bit linear, 128 times over-sampling
D/A: 24-bit linear, 128 times over-sampling
Signal Processing
  • Input summing
  • D-contour: FOH / MAIN
  • Monitor
  • OFF
  • Delay: 0 to 74 ms
  • HPF / LPF: cutoff frequency 20 Hz to 20 kHz with polarity control
  • Speaker Processor: 6-band PEQ / limiter / delay


Latency 1.5 ms (analog input to speaker)
User Presets 8 user presets
Factory Presets Speaker presets for Yamaha passive speakers
Connectors Analog Input
2 x XLR-3-31
2 x 1/4 TRSSpeakers
2 x Neutrik SpeakOn NL4
2 x pairs of binding posts
2 x 1/4″ TS1 x AC inlet with AC cord clamp1 x USB 2.0 Type-A (female)
Power Requirements 120 VAC / 60 Hz
Power Consumption 310 W at 4 Ohms, 1/8 maximum power
60 W at 4 Ohms, Idle
Operating Temperature 32 to 104°F / 0 to +40°C
Storage Temperature -4 to 140°F / -20 to +60°C
Dimensions (W × H × D) 18.90 x 3.46 x 15.25″ / 480 x 88 x 387.4 mm
Weight 16.31 lb / 7.4 kg
Packaging Info
Package Weight 20.5 lb
Box Dimensions (LxWxH) 21.75 x 21.75 x 7.5″


niyomsilp hi-fi & studio co.,ltd @2017 All Rights