Rated power bridge mode 8 Ohms: |
300Watts @ 1 kHz at <0.1% T.H.D. |
Rated power (2 X4 Ohms): |
150 Watts per channel @ 1 kHz at <0.1%
T.H.D. both channels driven |
Rated power (2 X 8 Ohms): |
100 Watts per channel @ 1 kHz at <0.1%
T.H.D.both channels driven |
Power bandwidth: |
10 Hz - 30kHz; +0, -0.5 dB at rated 80 Watts 8 Ohm power |
T.H.D.(2 X 4 Ohms): |
<0.05%@100 Watts per channel from 20 HZ to 20 kHz |
T.H.D.(2 X 8 Ohms): |
<0.05%@100Watts per channel from 20 HZ to 20 kHz |
Minimum load impedance: |
4 Ohms |
Maximum RMS voltage swing: |
37 Volts |
Frequency response: |
10 Hz - 100 kHz; +0, -3 dB at 1 Watt |
Input CMRR: |
>-65 dB @ 1 kHz |
Rated power (1 X 4 Ohms): |
180 Watts @ 1 kHz at <0.1% T.H.D. |
Rated power (1 X 8 Ohms): |
130 Watts @ 1 kHz at <0.1% T.H.D. |
Phase response: |
+5 to -15 from 20 Hz to 20 kHz |
Input impedance: |
10 k Ohms, balanced |
Cooling: |
Tow temperature dependant variable speed 40mm high output DC fans |
Controls: |
Two front panel attenuators, rear panel mode switch and gain select switch |
Voltage gain: |
0.775V, 32 dB or 26 dB |
Crosstalk: |
>-60 dB @ 1 kHz at rated power @ 8 Ohms |
Hum and noise: |
>-106 dB, "A" weighted referenced to rated power @ 8 Ohms |
Slew rate: |
>22V/us |
Damping factor (8 Ohms): |
>400:1 @ 20Hz - 1 kHz |
Indicator LEDs: |
2 Clip,2 signal presence, 1Bridge, 1 active status/Protection |
Protection: |
Thermal, DC, turn-on bursts, incorrect loads |
Connectors: |
XLR, Speakon and Binding Post speaker output, 240/230 Volt 16 amp IEC mains |
Construction: |
16 ga. Steel |
Dimensions: |
44 mm x 483 mm x 350 mm |
Net weight: |
8kg |
Gross weight: |
9kg |